For the Dreame A2, disc movement matters too
The Dreame A2 EdgeMaster system brings the disc closer to the lawn edge. Studying a Turbine Disc therefore requires assessing its mounting and the available space in the different plate positions, rather than its diameter alone.
What your help will allow us to check
Tell us the full A2 version, including 1200, 2000 or 3000 if shown on your mower. We will guide you through documenting the original plate and its clearances. Do not activate the cutting system to take measurements: we will agree on the required observations with the mower stopped according to the manufacturer’s instructions.
A guided test at home
Your mower stays with you. If selected, we explain which photos and measurements are needed, then arrange a possible loan of the original disc. Once the prototype is ready, you carry out the agreed validation test on your mower with our guidance and share your feedback.
Compatibility must be validated on your version
We collect different A2 references on this page without claiming shared compatibility before examination. An A1, A1 Pro, A3 or MOVA adaptation will not be transferred without validation. Testing must confirm the mounting and cutting-system operation, including near lawn edges.
Your kit at no charge
After completing your contribution and once a validated adaptation has been manufactured, you receive one Turbine Disc and the agreed blades for your mower. The exact kit and participation terms are confirmed before we begin. Applying alone does not entitle you to a kit.